WHLT-6P

TAILWHEEL, 6” PNEUMATIC

$354.65

Compare

Description

Matco Aircraft Landing Systems produces an superior six inch tail wheel for use with tail dragger aircraft which require a light weight tail wheel–the T-6P. New for 2009 is the 90 degree valve stem for easier filling!

Dimensions

The T-6P tail wheel has a six inch pneumatic tire and an overall length of 10.00 inches.Maximum width of this tail wheel with fully splayed arms is 9.29 inches and overall height is 9.71 inches.This assembly with pneumatic tire, tube, and wheel weighs 4.75 pounds.

Features

The T- 6P tail wheel has a .625 precision sealed ball bearing which is rigorously tested and designed to resist bearing fatigue providing a long bearing life. The pneumatic tire provides a most silent and smooth ride even when compared to our already smooth WHLT-6 solid wheel model.

The arms and wings of the tail wheel fork assembly are composed of 4130 which is heat treated to a Rockwell 38-43 to ensure strength and are irridited to prevent corrosion. The tail wheel base and forks are cast and then black anodized to prevent corrosion as well.

he T-6 tail wheel incorporates a geometric release mechanism that allows the wheel to caster after reaching a steered angle of 40 degrees (earlier release available with optional steering arms WHLT-03A). This allows the tail wheel assembly to be steerable and full swiveling and provides easy installation with variant spring tension.This wheel has been designed to release with light spring tension and can accomodate either a 1.25 or 1.50 wide flat spring (Use part number WHLTWB-1 adapter for 1.75 inch wide springs). When a 1.50 inch spring is used, a .1875 inch spacer may be used between the base and the spring.The assembly should be mounted on the flat spring so that the pivoting axle is as close to vertical as possible when the plane is loaded.

All assembly bushings are made of oil impregnated brass so only routine lubrication is needed during the life of the tail wheel.The ball bearings in the wheel assembly are sealed and do not require lubrication either.In addition, the vertical axle has been redesigned to .625 for added strength and durability.

The T-6P has a 3.5 inch aluminum wheel that uses a 6 inch pneumatic tire & tube and has an operating load of 250 pounds. The replacement tire and tube set is part number TIRT6X2ASY.  The WHLTW35 wheel used on this assembly is low profile when used with this tire.  The tire pressure should be maintained above 30 PSI to prevent rim strike on sharp taxiway discontinuities.

Additional information

Weight 4.8 lbs

Complementary Products

Bill of Materials